SC SERIES CYLINDERS ・Super Cylinders are ultimate precision actuators having the same size and construction as FC series , except equipped with Linear ball bearings. ・Absolute minimum of friction. ・Extremely sensitive response to pressure variations. ・Very low start-up pressure. Specifications Model Single Action ( Push ) / Double Action Cylinder Bore　mm 40 50 63 80 100 Stroke ※1 Single Action　mm 48 64 42 108 144 78 Double Action　mm 48 64 78 108 144 Working Fluid Compressed Air ( Non-lubricated ) Range of Working Pressure　MPa 0.01 to 0.7 Rod Bearing Linear ball bearing ( Non-Sealed / Sealed ) ※1 Range of Working Temperature　℃ 0 to 60 Mounting Direct, Rear Flange, Front Flange,Pivot, Trunnion, L-Mounting Note : ※ Super Cylinders of bore φ112 to φ200 are customized available as option only. ※1：When the Super Cylinder of Single action model is used in dusty environment, it is recommended to install Both-ends-sealed type of linear ball bearing, because only a few friction loss is added due to the seals. Nominal Size Table of Model SCS- and SCD- Cylinders SCS(D)- Bore Stroke 40 48 50 64 63 42 （SCS only） 78 80 108 100 144 112 156 125 178 140 204 　 SCS(D)- Bore Stroke 160 82 142 192 240 180 96 168 226 280 200 112 192 256 320 　 Note : Model SCS-and SCD- Cylinders ofbore not less than φ125 are customized ad options only. You are advised to contact our Control Products Section about the necessary delivering time. Ordering Information SCD − 40 − 48 − S0 − B0 − P �@ �A �B �C �D �E �@ �A �B �C Model Bore Stroke Spring SCS Single Action None Double Action SCD Double Action S0 None S1 Standard Spring �D �E Rod Bearing Mounting B0 Sealed - less None Body B1 Both - ends - ends - Sealed L Ell F Front Flange R Rear Flange T Trunnion P Pivot

For further details, refer to, Cat.No．KS−9137E For further details, refer to,CADdata

Back